WWW.CONSOLE-GEAR.CO.UK 

Our New Web Site Link --> Here

LINK TO OUR EBAY SHOP --> Here

XCMs XBOX 360 UNLOCK KIT 
case removal tools as shown in the instructions. This unlock tool is for removal and install of the xbox 360 case and for Modding fitting fans and Aurora Lights ect.  Not for the x clamp fix.
Link for the unlock kit_> Here

The X CLAMP TOOL KIT FOR THE XBOX 360 
UNLOCK TOOL T10 TORX & T8 SCREWDRIVER Link -> Here
This tool kit will take apart the XBOX 360 Case, Power Button, Heat Sink screws and the Main Board screws. This is the Tool kit to take the XBOX 360 apart for the X clamp fix.

We have instock the X CLAMP fix kit.
And other modding Accessories and the

ACCESS PRO TOOL KIT v2
OPENS ALL GAMES CONSOLES. Link  Here


Case Removal by XCM

1.Follow the instruction to take off the xbox 360 face plate..( can use a coin in red arrow groove to lever off)




2.Remove the bottom left rubber stand.

3.Follow the instruction to insert the XCM opening tool to the square hole (make it close to the edge of the hole then turn right as picture A, turn left as it shows on picture C)

As shown by the diagram B, the XCM opening tool is used for removing the inside piece of plastic lock.




4.Plug in the XCM opening tool to the base grille to take off the right heat panel.




5.Plug in the XCM opening tool to the base grille to take off the left heat panel.




6.Take the heat panels apart.




7.Remove seal.




8.Unplug the 4 buckles

9.Plug in our XCM opening tool to the indicated holes,  press it hard to let the top and bottom panels apart.

10.Take away the two parts




11.Remove the DVD drive Eject button.




12.As indicated by the arrow, remove the 6 screws by using the Allen key provided.




13.Remove the tray face plate.



14.All case components are displayed.